Einleitung

This guide explains how to re-attach the WiFi antenna.

Remove the 5.0mm screw using the Phillips #0 head screwdriver.
  • Remove the 5.0mm screw using the Phillips #0 head screwdriver.

Kommentar hinzufügen

Insert metal spudger as shown in the picture. Move spudger along  to the other side until both snaps come loose.
  • Insert metal spudger as shown in the picture. Move spudger along to the other side until both snaps come loose.

Kommentar hinzufügen

  • Picture shows the removed battery cover.

Kommentar hinzufügen

  • Slide the battery out by pulling on one of two plastics tabs.

Kommentar hinzufügen

  • Remove the remaining five 6.0 mm Phillips #0 screws.

Kommentar hinzufügen

  • Use the spudger to remove the back cover. Insert the spudger between the back and front cover. Once inserted, you will need to move it around the perimeter to release the snaps holding it together.

Kommentar hinzufügen

  • Once back cover is removed, the speaker wire will need to be removed. Use tweezers to remove wire.

Kommentar hinzufügen

  • Begin by heating the exposed end of the grey lead with the tip of a soldering iron while simultaneously pulling the lead away from the connection, using tweezers to grasp the lead by the insulation.

  • For more information on soldering, check out this repair guide: iFixit Soldering

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Yancey Crase

Mitglied seit 26.03.2018

217 Reputation

2 Anleitungen geschrieben

Team

IUPUI, Team S1-G4, Harley Spring 2018 Mitglied von IUPUI, Team S1-G4, Harley Spring 2018

IUPUI-HARLEY-S18S1G4

7 Mitglieder

5 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 3

Insgesamt: 52