Einleitung

Use this guide to replace your MacBook Air's AirPort/Bluetooth card.

  • Before proceeding, close your computer and lay it on a soft surface top-side down.

  • Remove the following ten screws:

    • Two 8 mm 5-point Pentalobe screws

    • Eight 2.5 mm 5-point Pentalobe screws

  • The special screwdriver needed to remove the eight 5-point Pentalobe screws can be found here.

I recommend that one of the tools you obtain is a jeweler's loupe that mounts on your glasses. It makes things easier.

blairweaver - Antwort

This is not correct. You need the pentalobe tool at this point.

Duane Hellums - Antwort

Wedge your fingers between the display and the lower case and pull upward to pop the lower case off the Air.
  • Wedge your fingers between the display and the lower case and pull upward to pop the lower case off the Air.

  • Remove the lower case and set it aside.

Kommentar hinzufügen

In this step you will disconnect the battery to help avoid shorting out any components during service. Use the flat end of a spudger to pry both short sides of the battery connector upward to disconnect it from its socket on the logic board.
  • In this step you will disconnect the battery to help avoid shorting out any components during service.

  • Use the flat end of a spudger to pry both short sides of the battery connector upward to disconnect it from its socket on the logic board.

  • Bend the battery cable slightly away from the logic board so the connector will not accidentally contact its socket.

Kommentar hinzufügen

Use the flat end of a spudger to pry both antenna connectors up from their sockets on the AirPort/Bluetooth card. Use the flat end of a spudger to pry both antenna connectors up from their sockets on the AirPort/Bluetooth card.
  • Use the flat end of a spudger to pry both antenna connectors up from their sockets on the AirPort/Bluetooth card.

Kommentar hinzufügen

Remove the single 2.9 mm T5 Torx screw securing the AirPort/Bluetooth card to the logic board.
  • Remove the single 2.9 mm T5 Torx screw securing the AirPort/Bluetooth card to the logic board.

Kommentar hinzufügen

Slightly lift the free end of the AirPort/Bluetooth board and pull it out of its socket on the logic board. Remove the AirPort/Bluetooth board from the Air.
  • Slightly lift the free end of the AirPort/Bluetooth board and pull it out of its socket on the logic board.

  • Remove the AirPort/Bluetooth board from the Air.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

8 weitere Nutzer haben diese Anleitung absolviert.

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 1

Letzte 7 Tage: 7

Letzte 30 Tage: 34

Insgesamt: 20,664