Zum Hauptinhalt wechseln

MacBook Air 11" Late 2010 Solid-State Drive Replacement

Was du brauchst

  1. MacBook Air 11" Late 2010 Solid-State Drive Replacement, Lower Case: Schritt 1, Bild 1 von 1
    In diesem Schritt verwendetes Werkzeug:
    P5 Pentalobe Screwdriver Retina MacBook Pro and Air
    $5.99
    Kaufen
    • Before proceeding, close your computer and lay it on a soft surface top-side down.

    • Remove the following ten screws:

    • Two 8 mm 5-point Pentalobe screws

    • Eight 2.5 mm 5-point Pentalobe screws

    • The special screwdriver needed to remove the eight 5-point Pentalobe screws can be found here.

    I recommend that one of the tools you obtain is a jeweler's loupe that mounts on your glasses. It makes things easier.

    blairweaver - Antwort

    This is not correct. You need the pentalobe tool at this point.

    Duane Hellums - Antwort

  2. MacBook Air 11" Late 2010 Solid-State Drive Replacement: Schritt 2, Bild 1 von 1
    • Wedge your fingers between the display and the lower case and pull upward to pop the lower case off the Air.

    • Remove the lower case and set it aside.

  3. MacBook Air 11" Late 2010 Solid-State Drive Replacement, Battery: Schritt 3, Bild 1 von 2 MacBook Air 11" Late 2010 Solid-State Drive Replacement, Battery: Schritt 3, Bild 2 von 2
    • In this step you will disconnect the battery to help avoid shorting out any components during service.

    • Use the flat end of a spudger to pry both short sides of the battery connector upward to disconnect it from its socket on the logic board.

    • Bend the battery cable slightly away from the logic board so the connector will not accidentally contact its socket.

  4. MacBook Air 11" Late 2010 Solid-State Drive Replacement, Solid-State Drive: Schritt 4, Bild 1 von 1
    • Remove the single 2.9 mm T5 Torx screw securing the SSD to the logic board.

    What happens if the 2.9mm t5 screw got stripped?

    Charles - Antwort

    So when i change my ssd in mac do i have to reinstall Mac OS

    sai prahalad Alluri - Antwort

    Correct, the SSD does not come with OS preinstalled. To install the OS you can completely clone your existing hard drive or you will need to create a bootable flash drive and format your SSD and create a partition in order to be able to install the OS.

    Ethan Lockwood -

    So my wife spilled a Martini on her MacAir and it no longer works and is not repairable, all her music and pictures are stored on the drive, I would like to transfer these files to another drive. What is needed to read the drive once removed?

    prastonis - Antwort

  5. MacBook Air 11" Late 2010 Solid-State Drive Replacement: Schritt 5, Bild 1 von 2 MacBook Air 11" Late 2010 Solid-State Drive Replacement: Schritt 5, Bild 2 von 2
    • Use a spudger to help lift the free end of the SSD just enough to grab it with your other hand.

    • Do not lift the end of the SSD excessively.

    • Pull the drive straight out of its socket and remove it from the logic board.

    • When reinstalling the SSD, be sure it is properly seated before reinstalling its retaining screw.

    I performed all the steps above and fitted a Transcend JetDrive 500 which was very easy however when I re-assembled and turned on all I get is a question mark in the middle of the screen, can you explain if I did anything wrong?

    Ian Ashton - Antwort

Abschluss

To reassemble your device, follow these instructions in reverse order.

36 weitere Nutzer:innen haben diese Anleitung absolviert.

3 Kommentare

is there any difference between SSD for macbook air and macbook pro...??

is that possible that we can just run macbook air only HDD..?

Rohit Lamba - Antwort

Any chance of squeezing in an SSD any larger than 256 GB?

Just bought a late-2010 11" MBA off Amazon Marketplace, which was actually advertised as mid-2011. My plan was to upgrade it with a 1 TB SSD, which wouldn't have been a problem with the mid-2011 model. Seems this is not going to work with this one, right?

mariawinter - Antwort

A bit of an oldie needs some help with upgrading his late 11" macbook air with a WD 500GB Blue SATA III 2.5" Internal SSD. Q 1 is it doable? Q2 Will I need an adapter "kit" of some kind or just be sure not to lose the screws in the process? Thanks in advance for any help. ted

Ted Buila - Antwort

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 9

Letzte 7 Tage: 30

Letzte 30 Tage: 196

Insgesamt: 109,127