Repariere deine Sachen Community Store

MacBook Air 13" Mid 2013 I/O Board Cable Replacement

Einleitung

Use this guide to replace the I/O board cable.

Was du brauchst

  1. MacBook Air 13" Mid 2013 I/O Board Cable Replacement, Lower Case: Schritt 1, Bild 1 von 1
    In diesem Schritt verwendetes Werkzeug:
    P5 Pentalobe Screwdriver Retina MacBook Pro and Air
    $5.99
    Kaufen

    • Before proceeding, power down your MacBook. Close the display and lay it on a soft surface, top-side down.

    • Use a P5 Pentalobe driver to remove ten screws securing the lower case, of the following lengths:

    • Two 9 mm screws

    • Eight 2.6 mm screws

    Übersetzen

  2. MacBook Air 13" Mid 2013 I/O Board Cable Replacement: Schritt 2, Bild 1 von 1

    • Wedge your fingers between the display and the lower case and pull upward to pop the lower case off the Air.

    • Remove the lower case and set it aside.

    Übersetzen

  4. MacBook Air 13" Mid 2013 I/O Board Cable Replacement, Battery Connector: Schritt 3, Bild 1 von 2 MacBook Air 13" Mid 2013 I/O Board Cable Replacement, Battery Connector: Schritt 3, Bild 2 von 2

    • To ensure that everything is de-energized and won't turn on while you're working, it is recommended that you disconnect the battery.

    • Grab the clear plastic pull tab attached to the battery connector and pull it parallel to the board toward the front edge of the Air.

    • Do not lift upward on the connector as you disconnect it or you risk damage to the connector socket.

    Übersetzen

  5. MacBook Air 13" Mid 2013 I/O Board Cable Replacement, I/O Board Cable: Schritt 4, Bild 1 von 1

    • Use the flat end of a spudger to pry the I/O board cable connector up out of its socket on the I/O board.

    Übersetzen

  6. MacBook Air 13" Mid 2013 I/O Board Cable Replacement: Schritt 5, Bild 1 von 1

    • Carefully peel the I/O board cable from the adhesive securing it to the top of the fan.

    • During reassembly, make sure this cable is in the correct orientation. It will fit if reversed, but the laptop will not boot.

    Übersetzen

  7. MacBook Air 13" Mid 2013 I/O Board Cable Replacement: Schritt 6, Bild 1 von 2 MacBook Air 13" Mid 2013 I/O Board Cable Replacement: Schritt 6, Bild 2 von 2

    • The following connector has an especially deep socket. Use care when disconnecting it.

    • While gently pulling the I/O board cable upward near its connection to the logic board, use the flat end of a spudger to pry up on alternating sides of the connector to help "walk" it out of its socket.

    • Remove the I/O board cable.

    Übersetzen
Abschluss

To reassemble your device, follow these instructions in reverse order.

7 weitere Nutzer:innen haben diese Anleitung absolviert.

0 Kommentare

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 0

Letzte 7 Tage: 7

Letzte 30 Tage: 20

Insgesamt: 7,075