Einleitung
Prereq for upper case.
Was du brauchst
-
-
Use the flat end of a spudger to pry and disconnect the three antenna cable connectors from the AirPort board.
-
Connect the long-sleeved cable to the center socket.
-
The short-sleeved cable connects next to the screw.
-
The remaining cable has no sleeve, and connects in the last empty socket, next to the fan.
-
-
-
-
Remove the following two screws securing the I/O board to the upper case:
-
One 3.53 mm T5 Torx screw
-
One 4.89 mm T8 Torx standoff screw
-
-
-
Carefully pull and remove the I/O board away from its recess in the upper case.
-
Fast fertig!
To reassemble your device, follow these instructions in reverse order.
Abschluss
To reassemble your device, follow these instructions in reverse order.
