Einleitung
Use this guide to replace a dead hard drive.
Was du brauchst
Einführungsvideo
-
-
Remove the following ten screws:
-
Three 14.4 mm Phillips #00 screws
-
Three 3.5 mm Phillips #00 screws
-
Four 3.5 mm shouldered Phillips #00 screws
-
-
-
Use your fingers to pry the lower case away from the body of the MacBook near the vent.
-
Remove the lower case.
-
-
-
Use the edge of a spudger to pry the battery connector upwards from its socket on the logic board.
-
-
-
-
Bend the battery cable slightly away from its socket on the logic board so it does not accidentally connect itself while you work.
-
-
-
Remove the two Phillips screws securing the hard drive bracket to the upper case.
-
-
-
Pull the hard drive cable away from the body of the hard drive.
-
Remove the hard drive.
-
-
-
Remove the four 6.0 mm T6 Torx hard drive retaining posts from the sides of the hard drive.
-
Transfer the hard drive retaining posts to your new hard drive.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
271 weitere Nutzer:innen haben diese Anleitung absolviert.
12 Kommentare
Is there any specific order that's best for putting back the screws?
Start with the corners but after that it dose not matter