Repariere deine Sachen Community Store

MacBook Pro 15" Unibody 2.53 GHz Mid 2009 (Anti-Glare Option) Bluetooth Board Replacement

Grundständige Anleitung
Dies ist eine grundständige Anleitung, die nur als Teil einer anderen Anleitung verwendet werden sollte.

Einleitung

This guide is an internal guide that is used only as a prereq.

Was du brauchst

  1. MacBook Pro 15" Unibody 2.53 GHz Mid 2009 (Anti-Glare Option) Bluetooth Board Replacement, (Anti-Glare Option) Bluetooth Board: Schritt 1, Bild 1 von 2 MacBook Pro 15" Unibody 2.53 GHz Mid 2009 (Anti-Glare Option) Bluetooth Board Replacement, (Anti-Glare Option) Bluetooth Board: Schritt 1, Bild 2 von 2

    • Disconnect the Bluetooth cable by pulling the male end straight away from its socket.

    • Pull the connector parallel to the face of the logic board, not straight up.

    • Use the flat end of a spudger to pry the Bluetooth antenna cable from its socket on the board.

    Übersetzen

  3. MacBook Pro 15" Unibody 2.53 GHz Mid 2009 (Anti-Glare Option) Bluetooth Board Replacement: Schritt 2, Bild 1 von 2 MacBook Pro 15" Unibody 2.53 GHz Mid 2009 (Anti-Glare Option) Bluetooth Board Replacement: Schritt 2, Bild 2 von 2

    • Remove the two 8 mm Phillips screws securing the Bluetooth/camera cable retainer to the upper case.

    • One of the screws may remain captive in the Bluetooth/camera cable ground loop. If replacing the display, be sure to transfer this screw to the new unit.

    • Lift the Bluetooth board/cable retainer assembly out of the upper case.

    Übersetzen
Abschluss

To reassemble your device, follow these instructions in reverse order.

0 Kommentare

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 0

Insgesamt: 1,861