Einleitung
This guide is an internal guide used as a prereq.
Was du brauchst
-
-
Use the flat end of a spudger to pry the AirPort/Bluetooth ribbon cable connector up off the logic board.
-
-
-
Disconnect the camera cable by pulling its connector away from the socket (toward the optical drive) on the logic board.
-
-
-
-
Use the flat end of a spudger to pry the optical drive connector up off the logic board.
-
-
-
Remove the two Phillips screws securing the AirPort/Bluetooth board housing.
-
Carefully rotate the AirPort/Bluetooth board housing (with AirPort/Antenna cables still attached) out of the lower case.
-
-
-
Remove the following three Phillips screws securing the optical drive to the upper case:
-
One 4.5 mm Phillips screw securing the optical drive bracket to the upper case near the fan.
-
Two 2.5 mm Phillips screws securing the optical drive to the upper case near the optical drive opening.
-
-
-
Lift the optical drive near its connector and pull it away from the upper case to remove it from the computer.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
