Einleitung
The keyboard has 3 main parts, including the speaker cover, the heat sink, and the keyboard itself. You have to remove these in order to remove the keyboard.
Was du brauchst
-
-
Turn the device upside down and then locate the battery latch near the front of the device.
-
-
-
Continue holding the latch then gently pull the CD-ROM Drive out of the device.
-
-
-
-
Press firmly on each end of the speaker cover and slide it to the left.
I found it was easy to get a spudger over the left edge and lift it up a bit, then push the bar to the left, It pops right off after that.
-
-
-
Locate the six screws that secure the heatsink.
This is not necessary to remove the HDD. Go directly to step 20.
-
-
-
Gently pull up on the beige ribbon lock until it moves a short distance on both sides to separate the ribbon cable from the connector.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.
Team
Cal Poly, Team 10-39, Forte Spring 2011 Mitglied von Cal Poly, Team 10-39, Forte Spring 2011
CPSU-FORTE-S11S10G39
5 Mitglieder
6 Anleitungen geschrieben
