Zum Hauptinhalt wechseln

Einleitung

You will be removing many pieces of hardware during this process. Store all of these pieces in a safe location so as not to lose them. Also, save all the pieces of tape and/or plastic that will be removed as they are very important in securing wires internally.

  1. Power off the Magellan RoadMate before beginning. Remove the six 5mm Phillips #00  screws from the back of device. Remove the six 5mm Phillips #00  screws from the back of device.
    • Power off the Magellan RoadMate before beginning.

    • Remove the six 5mm Phillips #00 screws from the back of device.

  2. Pry back cover off with a plastic opening tool just enough to see where the speaker is attached to the motherboard. Do not fully open the back cover or you risk damaging the speaker wire. Use a spudger to disconnect the speaker connection from the motherboard.
    • Pry back cover off with a plastic opening tool just enough to see where the speaker is attached to the motherboard.

    • Do not fully open the back cover or you risk damaging the speaker wire.

    • Use a spudger to disconnect the speaker connection from the motherboard.

  3. MacBook Akku Fix Kits

    Ab $69.99

    Buy Now

    MacBook Akku Fix Kits

    Ab $69.99

    Buy Now
  4. There will be two 5mm Phillips #00 screws that need to be removed from the motherboard. There will be two 5mm Phillips #00 screws that need to be removed from the motherboard. There will be two 5mm Phillips #00 screws that need to be removed from the motherboard.
    • There will be two 5mm Phillips #00 screws that need to be removed from the motherboard.

  5. Some devices may have a piece of tape or plastic over the ribbon cable latch.  If your device has this, remove it before continuing. Carefully lift the black ribbon cable latch upwards with a spudger or other similar tool. Once the ribbon cable latch is opened, insert the pointed end of the spudger, or other similar tool, underneath the ribbon cable.
    • Some devices may have a piece of tape or plastic over the ribbon cable latch. If your device has this, remove it before continuing.

    • Carefully lift the black ribbon cable latch upwards with a spudger or other similar tool.

    • Once the ribbon cable latch is opened, insert the pointed end of the spudger, or other similar tool, underneath the ribbon cable.

    • Slowly pull out the ribbon cable in a straight, flat motion with respect to the latch.

  6. Be careful not to touch any of the electrical components on the motherboard as damage may ensue. Carefully lift the motherboard out of the plastic housing by the edges while guiding the ribbon cable through the slot.
    • Be careful not to touch any of the electrical components on the motherboard as damage may ensue.

    • Carefully lift the motherboard out of the plastic housing by the edges while guiding the ribbon cable through the slot.

    • Store the motherboard on a safe non-conductive surface, preferably an anti-static mat.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Andrew Bading

Mitglied seit: 08.10.2016

132 Reputation

1 Anleitung geschrieben

Team

IUPUI, Team 4-4, Wilson Fall 2016 Mitglied von IUPUI, Team 4-4, Wilson Fall 2016

IUPUI-WILSON-F16S4G4

4 Mitglieder

6 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 7

Insgesamt: 189