Magic Bullet MB1001B Base Gear Replacement

Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.

Einleitung

Is your base gear worn down or broken? This guide will help you replace the base gear.

Was du brauchst

Schritt 1 Base Gear

Magic Bullet MB1001B Base Gear Replacement, Base Gear: Schritt 1, Bild 1 von 3

Magic Bullet MB1001B Base Gear Replacement, Base Gear: Schritt 1, Bild 2 von 3

Magic Bullet MB1001B Base Gear Replacement, Base Gear: Schritt 1, Bild 3 von 3

Use pliers to grip the gear inside of the top of the device.
You may have to remove a sticker that is covering the slit at the center of the bottom before completing the next step.
Insert a flathead screwdriver into the slit at the bottom of the device while still holding the pliers in place gripped on the gear.
Lay the device on its side. Holding the screwdriver stationary to hold the bottom side in place, use the pliers to unscrew the gear by turning the pliers CLOCKWISE.

Übersetzen

Abschluss

To reassemble your device, follow these instructions in reverse order.

9 weitere Nutzer:innen haben diese Anleitung absolviert.

Autor:in

mit 3 anderen Mitwirkenden

Jackson Wiley

Mitglied seit: 10/06/15

333 Reputation

1 Anleitung geschrieben

Auszeichnungen: 14

+ 11 weitere Auszeichnungen

Team

Cal Poly, Team 12-13, Maness Fall 2015 Mitglied von Cal Poly, Team 12-13, Maness Fall 2015

CPSU-MANESS-F15S12G13

4 Mitglieder

8 Anleitungen geschrieben

8 Kommentare

I am sure a black plastic piece that held the blades tight has broken off. I found pieces of it. How do I replace that piece and where can I get it? Everything is working fine, the motor is turning. The blade is too loose to stay in place while engaged.

cheryl ockrant - 2. Sep 2017 Antwort

Mine did while I was using it, looking for the same answer, I don't want to go out and buy a whole new set

Sheila Angeletti - 21. Sep 2017 Antwort

It can't be that both my sets of blades are bent. Should the clear plastic piece in the turn by hand?

sleepyhobbit - 1. Dez 2019 Antwort

Mine is on but the motor is working but the blades aren't spinning

Shenieza Singh - 2. Feb 2020 Antwort

Glued too hard. The old industrial revolution greed trick of having critical parts made of plastic to interface with metal. Programmed obsolescence. Garbage once broken. This guide should be rated difficult.

Chris J - 4. Mär 2020 Antwort