Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Was du brauchst
-
-
Use a #2 Phillips Head Screwdriver to unscrew the four 10 mm screws located on the bottom of the power base.
-
-
-
Use slight tension to remove the plastic base from the NutriBullet once all of the screws are removed.
-
-
-
-
Use a #2 Phillips Head Screwdriver to remove the two 10 mm screws that secure the white bracket down.
-
-
-
Use a #2 Phillips Head Screwdriver to remove the three 10mm screws that keep the base in place.
-
-
-
Use slight tension to remove the curved base by lifting it upward off of the outside casing.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.
Team
Cal Poly, Team 19-8, Maness Winter 2015 Mitglied von Cal Poly, Team 19-8, Maness Winter 2015
CPSU-MANESS-W15S19G8
4 Mitglieder
10 Anleitungen geschrieben
