Einleitung
This guide describes how to replace the camera and or gimbal for the Mavic 2 drone.
Was du brauchst
-
-
Remove the two 2x5 mm screws from the plastic piece near the camera on bottom side using the Allen key.
-
-
-
Remove ribbon cable connecting to camera by pulling at camera connection point.
-
-
-
-
Use Allen key to remove screws holding nose plate, in the front left and right corners in front of the camera.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Team
IUPUI, Team 2-3, Harley Fall 2023 Mitglied von IUPUI, Team 2-3, Harley Fall 2023
IUPUI-HARLEY-F23S2G3
3 Mitglieder
3 Anleitungen geschrieben
