Zum Hauptinhalt wechseln
  1. The access panel for all of these lights is on the inside of the trunk. There's one on each side. This guide will cover one side; simply repeat on the other to complete the job.
    • The access panel for all of these lights is on the inside of the trunk. There's one on each side. This guide will cover one side; simply repeat on the other to complete the job.

  2. The panel is secured with two thumb screws. Remove these.
    • The panel is secured with two thumb screws. Remove these.

  3. Pull the panel out and away from the back of the car, being careful not to force the bulbs out of the holes.
    • Pull the panel out and away from the back of the car, being careful not to force the bulbs out of the holes.

  4. MacBook Akku Fix Kits

    Ab $69.99

    Buy Now

    MacBook Akku Fix Kits

    Ab $69.99

    Buy Now
  5. There are five bulbs in each tail light housing. They are as follows:
    • There are five bulbs in each tail light housing. They are as follows:

    • Brake light

    • Reverse light

    • Tail light

    • Turn signal

    • Side marker

  6. To remove any of the bulbs simply turn them counter clockwise approximately a half turn and then pull them out of their socket.
    • To remove any of the bulbs simply turn them counter clockwise approximately a half turn and then pull them out of their socket.

  7. Three of the bulbs are #1156 One is a #96 One is a small 4W blub
    • Three of the bulbs are #1156

    • One is a #96

    • One is a small 4W blub

  8. Before installing the new bulb consider cleaning the socket with a soft metal wire brush such as the brass brush shown to help remove any corrosion.
    • Before installing the new bulb consider cleaning the socket with a soft metal wire brush such as the brass brush shown to help remove any corrosion.

    • Then install the new bulb, reassemble the device, and finally, be sure to test that all of your rear lights are working before going for a drive.

Abschluss

To reassemble your device, follow these instructions in reverse order.

7 weitere Nutzer haben diese Anleitung absolviert.

Nicolas Siemsen

Mitglied seit: 06.12.2013

30.996 Reputation

79 Anleitungen geschrieben

Team

Master Techs Mitglied von Master Techs

Community

286 Mitglieder

808 Anleitungen geschrieben

Very informative, descriptive and point on analysis.

George T Peeke - Antwort

Und wie wird dies beim Kombi gemacht?

srossius - Antwort

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 2

Letzte 7 Tage: 12

Letzte 30 Tage: 59

Insgesamt: 6,689