Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Einleitung
This shows how the remove the motherboard from the Kinect. All of the components of the Kinect run through the motherboard. If the Kinect wont turn on or a component isn't working it may be an issue with the motherboard not the component itself.
Was du brauchst
-
-
Remove the two plastic strips off the bottom of the main Kinect housing using the metal spudger's sharper side.
-
Peel off the two Xbox 360 stickers from the bottom of the case to reveal two hidden screws.
-
-
-
Remove the top portion of the case from the rest of the body.
-
Detach the side portions of the case from the body.
-
Remove the fan piece from the side of the body. Unplug it from the logic board to fully remove it.
-
-
-
-
Remove the front portion of the case containing the lens coverings for the cameras.
-
The LED component is connected to the front portion of the case. To disconnect it, just pull it out of its plastic connector.
-
-
-
Pull off the microphone panel and snake the cable that was connected to the motherboard through the hole on the camera panel.
-
-
-
Disconnect the bridge connecting the first and second layer of the motherboard.
-
Pull the first layer of the motherboard off.
-
-
-
Unscrew the three 16.5mm screws using the 5mm Nut Driver.
-
Unscrew the one 6.5mm T10 Torx screw.
-
-
-
Remove the three ribbon cables.
-
Disconnect the left most camera from the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
2 weitere Nutzer:innen haben diese Anleitung absolviert.