Einleitung
To replace the Surface 3 audio jack, you will need to remove the casing, undo various restraints that keep the audio jack in place, and, finally, remove and replace the audio jack itself.
Was du brauchst
-
-
Warm up an iOpener following the instructions found in the iOpener guide.
-
Place the warm iOpener on top of the edges of the screen. This heat will weaken the strength of the adhesive between the display and body.
-
-
-
Use iFixit opening picks to wedge under the edge of the screen at the speaker port.
-
-
-
Carefully try to work your way around the device using the picks, reapplications of the heated iOpener, and luck.
-
-
-
Flip the display over so that parts underneath it are easily accessible.
Please note that the WIFI antenna can become stuck to the display. It is located on the black plastic to the right of the camera and can be easily disconnected accidentally. Excellent guide otherwise.
I second this comment. Didn’t know it was there. The surface 3 pro guide clearly warns of this in the takeapart.
-
-
-
-
You will be working in this area of the Surface 3 when replacing the audio jack and Micro SD port
-
-
-
Remove the black adhesive covering next to the audio jack in order to get to the screws underneath.
-
-
-
Remove the silver bracket using the black pick in order to properly remove the entire audio jack.
-
-
-
Carefully remove the entire audio jack . It should look like the picture of the single part to the left.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
4 weitere Nutzer:innen haben diese Anleitung absolviert.
no, I didn't break the screen upon removing batteries.
Robert Hale - Antwort