Einleitung
The Surface Pro 4's heat sink cooling system consists of copper tubing and a connected copper plate. Here is how to remove it for replacement or to access the components below.
Was du brauchst
-
-
Both sections of the heat sink are connected to the motherboard via a panel which is covered by a metal casing.
-
Remove the casing by prying around the edges and then lifting the entire piece once it is loose.
-
-
-
Remove the four 1.5mm Torx T4 screws holding the main body of the heat sink to the motherboard
-
-
-
-
Remove the two 1.5mm Torx T3 screw holding the copper plate near the middle of the device.
-
-
-
Remove the 1.5mm Torx T4 screw holding the heat sink tubing to the frame of the device.
-
Remove the 3.0mm Torx T4 screw.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
10 weitere Nutzer:innen haben diese Anleitung absolviert.
Team
Metro State, Team 1-3, Carpenter Spring 2016 Mitglied von Metro State, Team 1-3, Carpenter Spring 2016
MSU-CARPENTER-S16S1G3
2 Mitglieder
12 Anleitungen geschrieben
