Einleitung
Use this guide to replace the charging port in a Microsoft Surface Pro.
Was du brauchst
-
-
Use a heated iOpener or a heat gun to heat the edges of the display and soften its adhesive.
-
-
-
Apply a suction cup as close as possible to the edge of the display.
-
Use the suction cup to lift the edge of the display enough to insert an opening pick under the edge.
-
Slide the opening pick all the way around the edges of the display to cut through the adhesive on the bezel.
-
-
-
Starting from the top edge, lift the display slightly. If you feel any resistance, use heat and an opening pick to slice through any remaining adhesive.
-
Before completely removing the display, disconnect the three display cables.
-
-
-
-
Using a T5 Torx screwdriver, unscrew a total number of 23 screws located on the outside panel of the Surface Pro.
-
-
-
Use the T5 torx screw driver to unscrew the 6 T5 screws in the left and right outside metal panels
-
Use the T2 torx screw driver to unscrew the 23 T2 screws on the left and right outside metal panels
-
-
-
Once you have unscrewed the charging port, you can gently pull it out with your hands.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
5 weitere Nutzer:innen haben diese Anleitung absolviert.
4 Kommentare
Where do you get a replacement charging port at?