Einleitung

Use this guide to replace the pull-out antenna through the back of the device.

Ersatzteile

Kein Ersatzteil erforderlich.

Remove the battery by sliding it down the rails to which it is connected.
  • Remove the battery by sliding it down the rails to which it is connected.

Kommentar hinzufügen

Locate a Flat-head or a Phillips head screwdriver.
  • Locate a Flat-head or a Phillips head screwdriver.

  • Insert the screwdriver into the holes that connect the key pad guard to the rear casing in the plastic rod.

  • The following step may require a substantial amount of force.

  • Use the screwdriver to push the rods towards each other until they click out of their locked positions.

Kommentar hinzufügen

Slide off the antenna guard and locate the four clips on the exterior of the rear casing.
  • Slide off the antenna guard and locate the four clips on the exterior of the rear casing.

  • Simultaneously push the clips outward while lifting the rear casing and keyguard away from the front casing.

Kommentar hinzufügen

Locate and unplug the black component of the current antenna from the motherboard.
  • Locate and unplug the black component of the current antenna from the motherboard.

  • Under the black component should be a blue component. Unscrew this component in order to free the antenna.

Kommentar hinzufügen

Slide the antenna out of the green tubing.
  • Slide the antenna out of the green tubing.

  • Slide the green tubing out of its hole.

Kommentar hinzufügen

Insert the new green tubing into the corresponding slot.
  • Insert the new green tubing into the corresponding slot.

Kommentar hinzufügen

Insert the new antenna into the green tubing.
  • Insert the new antenna into the green tubing.

Kommentar hinzufügen

Screw the blue piece of the antenna into the threaded hole on the motherboard until it is tight.
  • Screw the blue piece of the antenna into the threaded hole on the motherboard until it is tight.

Kommentar hinzufügen

Align the protruding wire on the black component with the corresponding hole on the motherboard.
  • Align the protruding wire on the black component with the corresponding hole on the motherboard.

  • Push the wire into the hole.

Kommentar hinzufügen

Reverse the instructions from Step 2 to re-install the keypad guard and rear casing onto the device.
  • Reverse the instructions from Step 2 to re-install the keypad guard and rear casing onto the device.

Kommentar hinzufügen

Push down on the antenna guard until it clicks into place.
  • Push down on the antenna guard until it clicks into place.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Andrew Lam

Mitglied seit 17.04.2012

28 Reputation

5 Anleitungen geschrieben

Team

Cal Poly, Team 9-46, Regan Spring 2012 Mitglied von Cal Poly, Team 9-46, Regan Spring 2012

CPSU-REGAN-S12S9G46

5 Mitglieder

8 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 1

Letzte 7 Tage: 2

Letzte 30 Tage: 5

Insgesamt: 1,442