Einleitung
Motherboard installation requires a teardown of the device.
Was du brauchst
-
-
Remove the battery by sliding it down the rails to which it is connected.
-
-
-
Find a flat head or Phillips head screwdriver.
-
Insert the screwdriver into the holes in the plastic rod connecting the key pad guard to the rear casing.
-
Use the screwdriver to push the rods towards each other until they click out of their locked position.
-
-
-
Slide off the antenna guard and locate the four clips on the exterior of the rear casing.
-
Simultaneously push the clips outward while lifting the rear casing and keyguard away from the front casing.
-
Remove the key guard from the rear casing by taking it out of its position.
-
-
-
-
Locate and unplug the black component of the antenna from the motherboard.
-
Under the black component should be a blue component. Unscrew this component in order to free the antenna.
-
-
-
Slide the antenna out of the green tubing and slide the green tubing out of it's corresponding hole on the motherboard.
-
-
-
With your new motherboard, hold the LCD side of the motherboard face down. Align the four clips on the front casing with the four notches on the motherboard.
-
While doing so, insert the LCD into the compartment in the front casing.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.
Team
Cal Poly, Team 9-46, Regan Spring 2012 Mitglied von Cal Poly, Team 9-46, Regan Spring 2012
CPSU-REGAN-S12S9G46
5 Mitglieder
8 Anleitungen geschrieben
