Einleitung
Diese Anleitung zeigt dir, wie du den Mittelrahmen an deinem Motorola Droid Turbo austauschen kannst.
Was du brauchst
-
-
Bereite einen iOpener vor und lege ihn über die Rückseite um die Klebeverbindung darunter aufzuweichen.
-
-
-
Heble die Rückseite mit einem Plastiköffnungswerkzeug ab.
-
Entferne die Rückseite.
I had to go around the case, starting on the non-button side, around the top and then the other side. This, unfortunately, pulled on the rear case, pressed the power button and turned the device back on. I would suggest starting on the button side and going around.
-
-
-
-
Entferne die Blende um den Mittelrahmen.
-
-
-
Die Platte des Mittelrahmens ist mit vier Torx T5 Schrauben befestigt. Drehe sie heraus.
Step 4, there are also 2 T shaped tabs on the sides locking the mid frame plate. Above them you can see an angled hole where you can insert a paper clip to push them out and up to unlock them.
The WiFi on the Turbo I’m working on has stopped working. The phone was reset to factory to see if this would fix it after all other try-this-first methods to fix had failed. I opened it to check there and find nothing apparently wrong.. No bent connectors or dirty pins. Any suggestions? I started to clean this section with alcohol but decided I’d better ask first. Any suggestions?
-
-
-
Nimm den Mittelrahmen heraus.
There's two clips to the left and the right of the midframe. Use a SIM tool and insert them into the holes above the clips, and push the clips out from the inside. Once both have been pushed the midframe is released.
Many ANY thanks for that additional tip. Rather important!
-
Um dein Gerät wieder zusammen zu setzen folge den Schritten in umgekehrter Reihenfolge.
Um dein Gerät wieder zusammen zu setzen folge den Schritten in umgekehrter Reihenfolge.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.
Besonderer Dank geht an diese Übersetzer:innen:
100%
VauWeh hilft uns, die Welt in Ordnung zu bringen! Wie kann ich mithelfen?
Hier starten ›
This di not work; I had to use a blow dryer.
Caroline Downie - Antwort