Diese Übersetzung enthält möglicherweise noch nicht die neuesten Änderungen der Original-Anleitung. Hilf mit, die Übersetzung zu aktualisieren oder sieh dir die Original-Anleitung an.
Einleitung
Mit Hilfe dieser Anleitung kannst du die Lautsprecher eines Moto G2 austauschen. Der Austausch selbst ist nicht schwierig, allerdings musst du dich vorher durch einige Schichten durcharbeiten. Du benötigst nur einen Torx T5 Schrauber und einen Plastiköffner.
Was du brauchst
-
-
Beginne am USB-Anschluss mit dem Ablösen der Rückabdeckung mit dem Finger.
-
Löse weiter den Seiten entlang ab, zerbrich dabei nicht den Rückdeckel.
-
-
-
Drehe acht 4,2 mm T5 Schrauben am oberen und unteren Ende heraus.
-
Mit dem gleichen Schrauber kannst du die sechs 3,2 mm Schrauben an den Seiten entfernen.
-
Jetzt kannst du die nächste Schicht des Handys mit den Fingern ablösen.
On mine, they’re all Torx T5
You neglected to mention that the two buttons might fall out when you remove this part.
-
-
-
Mit dem Plastiköffner oder einer Pinzette kannst du den SIM/SD Kartenleser entkoppeln.
-
Öffne den Akkuverbinder indem du ihn von der Hauptplatine ziehst.
-
Entkopple den Vibrationsmotor indem du seinen Stecker von der Hauptplatine löst.
There's no need to remove the battery or motherboard to get to the speakers - they are accessible as soon as the back cover is removed. Skip this step and jump straight to step 10
In fact it is not necessary to remove the simcard rack. I managed to remove battery with the rack on. It is possible to remove the foil startingfrom the bottom of the battery and once peeled off the battery can be removed. You only need to disconnect the battery from the mother board.
-
-
-
Mit dem Plastiköffner kannst du ganz vorsichtig die gesamte SIM/SD Kartenleseeinheit ablösen.
-
Der Akku kann auch ausgebaut werden, ohne den SIM/SD-Kartenleser zu entfernen. Du musst nur einfach die Kupferfolie vom gegenüberliegenden Ende her abziehen und vor dem SIM/SD-Kartenleser anhalten.
As mentioned in a comment on the previous step, you don’t actually need to remove the SIM/SD card reader at all.
If you peel back the copper foil from the opposite end of the device, you can sneak the battery out (and the new battery in) by just sliding the battery ribbon cable out from under the SIM/SD card reader.
Thx for the idea. I’ll let you know if it was working - I’ll my battery soon. regards!
Perfect as mentioned - just slide the cable foil under the sim rack - no need to remove the rack. Works flawlessly, quick repair.
-
-
-
-
Mit dem Finger kannst du die beiden Klebestreifen auf dem Akku abheben.
-
Entferne den Akku indem du die rechte Seite hochziehst.
If the copper foil is damaged beyond repair, what can be used to replace it?
-
-
-
Löse den Stecker des Displaykabels indem du die schwarze Plastikklappe anhebst.
-
-
-
Mit dem T5 Schrauber kannst du die drei 2,2 mm Schrauben ausdrehen, die die Hauptplatine befestigen.
-
-
-
Hebe die Platine vorsichtig heraus.
-
-
-
Hier findest du die Lautsprecher, wenn die Hauptplatine weg ist.
-
-
-
Die Hauptplatine ist entfernt. Mit einer Pinzette kannst du den oberen Lautsprecher vorsichtig anpacken.
-
Entferne ihn und setze den neuen wieder ein.
Speaker not working after replacement, what is trick to setting the correct height of the speaker to make proper contact with the spring terminals?
-
-
-
Mit einer Pinzette kannst du den unteren Lautsprecher vorsichtig anpacken.
-
Entferne ihn und setze den neuen wieder ein.
-
Um das Handy wieder zusammen zu bauen folge den Schritten in umgekehrter Reihenfolge.
Um das Handy wieder zusammen zu bauen folge den Schritten in umgekehrter Reihenfolge.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
16 weitere Nutzer:innen haben diese Anleitung absolviert.
Besonderer Dank geht an diese Übersetzer:innen:
85%
VauWeh hilft uns, die Welt in Ordnung zu bringen! Wie kann ich mithelfen?
Hier starten ›
10 Kommentare
Same problem happened to me when I replaced the screen, had to remove the speaker and when I put it back the upper (left) didn't work and the lower (right) had terrible distortion noise. playing a little with the upper speaker location made it work but with noise as well.
The phone is useless without this speaker, it's pretty shame that nobody pays attention to this point in their guides.
Have you fixed your speakers? Did you at least discovered why it happened?
I had a similar problem after replacing my battery. After I put the phone back together, my bottom speaker was not working. I went ahead and ordered a speaker to replace the one that was not working, and it still didn't work. Knowing that my top speaker was working okay, I replaced the top speaker to see if the new one I received was working, and it didn't work on top either. As a matter of fact, I put back the original top speaker that was working okay, and now it doesn't work. So now neither one of them are working. I have to use earphones to hear my phone. I don't know what happened. The instructions to replace the speakers are not that difficult.
Does anyone have any suggestions on what I should do? I'm not ready to give up my phone just yet.
Betsey -
To corroborate with the other commenters: removing the motherboard is unnecessary. The speakers are only held in with a small ring of adhesive, which can easily be pried out. Additionally, the two speakers are identical.
I was having trouble removing the adhesive copper foil above the battery, most of it ripped and is ruined. How much will that affect phone performance?
I had no sound after replacing my screen, but it's kind of working now after footering about, so I thought I'd share my thoughts for anyone in a similar predicament (I'm very much a chancer - happy to be corrected by someone who knows what they're on about!)
It seems like the speakers are connected via conductors on the back panel. I think the reason I had no sound after transferring them (along with everything else) to the new screen assembly was that the clear plastic/adhesive bit on the new thing wasn't thick enough, so the speaker wasn't being pressed against the back panel hard enough to make a good contact. I swapped this in from the old one and hey presto! A bit distorted, but working :)
So when performing Steps 10 and 11, make sure you don't leave a bit of transparent plastic behind - I'm not sure whether this is additional to the adhesive, or whether it's just turned hard in the meantime, but either way, the speaker needs to be at a certain height to work.
I have the same problem as others. After I replaced the display, the speaker don’t work anymore.
I’m buying new one but I need to know, Are the two speakers identical?
Important - remove SIM cards before opening the phone.
Wojciech Dyba - Antwort