Einleitung
This guide will show each detailed step to removing and replacing the battery in the Motorola G7 Play, model number XT1952-3 or XT1952-2. The battery is what keeps the device powered when disconnected from a charger. If the device does not power on or does not hold a charge this can possibly mean that the battery is no longer working. Look out for a swollen or leaking battery. If there is a swollen or leaking battery, be cautious and follow iFixit’s guide on what to do if a battery is swollen.
Was du brauchst
-
-
Insert a paperclip or SIM card eject tool into the small hole in the SIM card tray on the right side of the top edge of the phone.
-
Press the tool into the hole to eject the tray.
-
Remove SIM Card Tray.
-
-
-
Use the iFixit pick and the iFixit opening tool to pull the fingerprint scanner off of the back case.
-
-
-
Next, remove the nine 3.2mm Phillips #00 screws from the motherboard cover with a 00 Phillips bit.
-
-
-
-
Using an iFixit opener tool, detach the fingerprint sensor and the other 5 cables from the motherboard.
-
-
-
Remove the 0.4mm Phillips #00 screw from the motherboard with a 00 Phillips bit.
-
-
-
Remove the six 3.2 mm screws from the charging port assembly cover with a Phillips #00 screwdriver.
-
Remove the cover.
-
-
-
Using the iFixit opening tool, carefully pry up the charging port assembly cover.
-
-
-
Using an iFixit opening tool, detach the cables from the charging port assembly.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
14 weitere Nutzer:innen haben diese Anleitung absolviert.
Team
Cal Poly, Team S7-G4, Regan Winter 2020 Mitglied von Cal Poly, Team S7-G4, Regan Winter 2020
CPSU-REGAN-W20S7G4
5 Mitglieder
12 Anleitungen geschrieben
6 Kommentare
I found this useful although I was dismantling a G7 Power. The screws are in different places but most parts and the the battery are the same or similar. Fortunately, though I discovered that steps 8, 9 and 13 were unnecessary. The motherboard and charging boards could be left in place (only the plastic covers had to come off) while the battery was removed.
I successfully changed a battery on a G7 Play. I skipped steps 4, 7, 8, 10, 11, 12, 13, 14, and 15. The instructions for removing the battery are risky. I pried the battery up a little and put constant pressure on it until it came loose which took about 60 seconds. The battery comes with a tiny connector at the end of a ribbon cable. This is plugged into a board, and then the motherboard holds it in place. In general, the phone is not designed for the battery to be replaced which surprised me.
Thank you! I successfully disassembled my G7 Play after an unfortunate dive in a lake to let it completely dry. It's now working as new!
