Einleitung
Though not necessary, it is recommended that the battery is removed before removing the rear camera, simply for safety reasons.
Was du brauchst
-
-
Use the flat edge of a spudger to push the grille from the front side of the screen to loosen it from its recess.
-
Remove the grille.
-
-
-
If your replacement part did not come with a lower microphone gasket, use tweezers to carefully peel it from your old screen and transfer it to your replacement part.
-
-
-
-
Use flat edge of the spudger to pry up the two blue connectors near the top of the device.
-
-
-
Using a pair of tweezers disconnect the vibrating motors connector near the bottom of the device.
-
-
-
Using a T3 Torx screwdriver, remove both 1cm screws. To do this, insert the screwdriver into the head of the screw, then turn counter-clockwise.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
3 weitere Nutzer:innen haben diese Anleitung absolviert.