Einleitung

Is the plastic casing cracked or severely scratched? Replace it.

Using your finger, press down on the clip holding the back cover on.
  • Using your finger, press down on the clip holding the back cover on.

Kommentar hinzufügen

Using the spudger or your finger, gently pull the battery out from the top.
  • Using the spudger or your finger, gently pull the battery out from the top.

Kommentar hinzufügen

Hold the phone as shown in the photo.
  • Hold the phone as shown in the photo.

Kommentar hinzufügen

Using the flat side of the spudger and a little pressure, insert it under the bottom plastic piece at about center. This might require a little persistence due how the beveled plastic rests on the phone body.
  • Using the flat side of the spudger and a little pressure, insert it under the bottom plastic piece at about center.

  • This might require a little persistence due how the beveled plastic rests on the phone body.

  • After the spudger is under the plastic piece, move counter clockwise using a gentle twisting motion until the piece is free from the phone body.

Kommentar hinzufügen

Remove the two Torx-6 screws under the removed plastic.
  • Remove the two Torx-6 screws under the removed plastic.

Kommentar hinzufügen

Keeping the phone open, turn it over allowing the battery compartment to be visible.
  • Keeping the phone open, turn it over allowing the battery compartment to be visible.

  • Remove the four Torx-6 screws from the back plastic.

Kommentar hinzufügen

Hold the phone with the keys facing down and the mini USB charging port visible. Open the rubber flap covering the charging port. Insert the flat end of the spudger just above the charging port.
  • Hold the phone with the keys facing down and the mini USB charging port visible.

  • Open the rubber flap covering the charging port.

  • Insert the flat end of the spudger just above the charging port.

  • Using the same gentle twisting motion, work around the bottom of the phone and up the opposite side. The back casing should separate from the body of the phone.

  • When working on the thinner pieces of the plastic casing, use caution insuring the plastic does not crack.

Kommentar hinzufügen

The casing can be easily removed exposing the bottom logic board.
  • The casing can be easily removed exposing the bottom logic board.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Austin Hobbs

Mitglied seit 21.01.2010

30 Reputation

6 Anleitungen geschrieben

Team

Cal Poly, Team 8-50, Regan Winter 2010 Mitglied von Cal Poly, Team 8-50, Regan Winter 2010

CPSU-REGAN-W10S8G50

3 Mitglieder

14 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 0

Insgesamt: 3,250