Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Was du brauchst
-
-
Using the plastic opening tools, pry the left bottom corner of the battery up.
-
-
-
Remove the two Torx T5 screws.
-
Remove the one Philips #00 screw.
-
-
-
Using the plastic opening tool, pry up the battery housing upwards.
-
Push pry tool down, undoing the plastic tab.
-
-
-
-
Using the plastic opening tool, push the blade into the space between the case and lower cover.
-
Turn the opening tool slightly, the lower cover will detach on that side.
-
Repeat on other side of the seam.
-
The lower cover will slide off.
-
-
-
Remove the one T5 Torx screw
-
Remove the one #00 Philips screw
-
Lift up the end of the antenna housing and slide it outwards.
-
-
-
Insert the spudger under the connector.
-
Push the spudger up and twist to release the connector.
-
Repeat for the next connector.
-
-
-
Push on the USB port to expose the black connector.
-
Use the spudger to pry the connector upwards.
-
-
-
Insert the spudger into tab above the camera.
-
Slide upwards until the board detaches from the case.
-
-
-
Press the pointed tip of the spudger into the space below the button assembly.
-
Wiggle the spudger tip towards the outside of the button.
-
-
-
Push the pointed tip of the spudger into the base of the side button board.
-
Lift up, the board will disconnect from the case.
-
-
-
Push on the lower motherboard until it slides under the case support.
-
The motherboard assembly comes out as a single piece.
-
Save the small black rubber rectangular sound guide under the motherboard, to replace over the microphone.
-
-
-
Using the spudger, lift the blue colored connector.
-
Use the supdger to lift the black connetor up as well.
-
Detach the upper motherboard from the lower motherboard.
-
-
-
Use the spudger to lift the SIM card tray connector off the motherboard.
-
-
-
Use the spudger to lift the SIM tray board off the motherboard.
-
The SIM Tray hinges up, it is still connected by the copper tape.
-
add picture of SIM tray flipped over the side to complete guide.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
