Einleitung

If your rear casing needs to be replaced, if it's been cracked for example, follow this guide to remove the current rear case. In this guide ZxY denotes a screw with Z-length and Y-width.

Ersatzteile

Kein Ersatzteil erforderlich.

On the bottom right of the camera, locate the battery flap switch.
  • On the bottom right of the camera, locate the battery flap switch.

Kommentar hinzufügen

Move this switch to the right so the battery flap can flip open.
  • Move this switch to the right so the battery flap can flip open.

Kommentar hinzufügen

  • Slide the orange switch to the right as shown. Now the battery can be pulled out. Reverse these steps to re-install.

Kommentar hinzufügen

  • Remove the three 3x3mm screws attached to the rear casing.

Kommentar hinzufügen

  • The panel can be identified by the wifi logo on its upper half on the camera's side.

  • Remove the 5x3mm screw holding down the panel on the side closest to the lens.

Kommentar hinzufügen

  • Pry the panel off from the bottom using your fingernail.

Kommentar hinzufügen

  • Remove the 3x2mm screw underneath the panel near the top of the camera.

Kommentar hinzufügen

  • Remove the 4x3mm on the opposite side near the selector wheel.

  • Remove the 2x2mm and 3x2mm screws underneath the a/v flap.

Kommentar hinzufügen

  • Pry the back panel away from the body of the camera, using the space you just opened up.

  • Be careful not to damage the ribbon cable on the opposite end of the camera.

  • A small piece of the frame of the camera may fall off, but it can be easily put back into place during reassembly.

Kommentar hinzufügen

  • Pry up the plastic ribbon connectors on the body of the camera to release the ribbon cables.

  • The center connector is detached by flipping the black latch up and away from the center of the camera.

  • The smaller connector is detached by flipping the tan latch up and away from the edge of the camera.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Ein weiterer Nutzer hat diese Anleitung absolviert.

Kevin Backers

Mitglied seit 26.01.2012

301 Reputation

4 Anleitungen geschrieben

Team

Cal Poly, Team 9-5, Regan Winter 2012 Mitglied von Cal Poly, Team 9-5, Regan Winter 2012

CPSU-REGAN-W12S9G5

5 Mitglieder

6 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 3

Insgesamt: 774