Repariere deine Sachen Community Store

Nikon Coolpix S630 Battery Cover Door Replacement

Einleitung

Before replacing your battery cover door for your Nikon Coolpix S630 you would need to read how to remove back panel and front panel. Removing both back and front panels are necessary to starting this guide.

Was du brauchst

  1. Nikon Coolpix S630 Battery Cover Door Replacement, Battery Compartment: Schritt 1, Bild 1 von 1

    • The battery compartment is located on the bottom of the camera.

    • Place your thumb on the battery door.

    • Slide the door away from the camera in the direction the arrow points to.

    Übersetzen

  2. Nikon Coolpix S630 Battery Cover Door Replacement, Battery: Schritt 2, Bild 1 von 1

    • Slide the yellow tab towards the back of the camera.

    • The battery should pop out.

    • Remove the battery.

    Übersetzen

  3. Nikon Coolpix S630 Battery Cover Door Replacement, Memory Card: Schritt 3, Bild 1 von 1

    • Press the memory card down into the camera.

    • The memory card should pop out.

    • Remove the memory card.

    Übersetzen

  4. Nikon Coolpix S630 Battery Cover Door Replacement, Back Cover Removal: Schritt 4, Bild 1 von 3 Nikon Coolpix S630 Battery Cover Door Replacement, Back Cover Removal: Schritt 4, Bild 2 von 3 Nikon Coolpix S630 Battery Cover Door Replacement, Back Cover Removal: Schritt 4, Bild 3 von 3

    • Unscrew the two 3.5mm Phillips screws from the side with the AV outlet.

    • Unscrew the 3.5mm Phillips screw from the opposite side of the camera.

    • Unscrew the six 3.5mm Phillips screws from the bottom of the camera.

    Übersetzen

  5. Nikon Coolpix S630 Battery Cover Door Replacement: Schritt 5, Bild 1 von 1

    • Carefully remove the back casing from the camera.

    • Be mindful when removing the back casing as there is a ribbon that still connects the back casing to the motherboard.

    Übersetzen

  7. Nikon Coolpix S630 Battery Cover Door Replacement, Detaching Ribbon: Schritt 6, Bild 1 von 2 Nikon Coolpix S630 Battery Cover Door Replacement, Detaching Ribbon: Schritt 6, Bild 2 von 2

    • Place the plastic opening tool underneath the ribbon tab as shown. Gently lift the tab up.

    • Gently pull the ribbon from the logic board with tweezers.

    • With the ribbon disconnected, the back casing should now be detached from the rest of the camera.

    Übersetzen

  8. Nikon Coolpix S630 Battery Cover Door Replacement, Front Cover: Schritt 7, Bild 1 von 1

    • Locate a small, rectangular flap above the battery cover door.

    • Push the small, rectangular flap back through the hole.

    Übersetzen

  9. Nikon Coolpix S630 Battery Cover Door Replacement: Schritt 8, Bild 1 von 1

    • Using the plastic opening tool, gently pry open the front cover. Gently remove the front cover.

    • Make sure to hold the camera down when removing the front cover.

    Übersetzen

  10. Nikon Coolpix S630 Battery Cover Door Replacement, Battery Cover Door: Schritt 9, Bild 1 von 1

    • Locate the battery cover door.

    Übersetzen

  11. Nikon Coolpix S630 Battery Cover Door Replacement: Schritt 10, Bild 1 von 2 Nikon Coolpix S630 Battery Cover Door Replacement: Schritt 10, Bild 2 von 2

    • Press and slide the cover door open.

    Übersetzen

  12. Nikon Coolpix S630 Battery Cover Door Replacement: Schritt 11, Bild 1 von 1

    • Locate the small rod that is securing the door in place

    • Using a tweezers, grab the rod and slowly pull the rod out

    • Note: Be careful as you try to pull the rod out because the spring may pop out

    Übersetzen

  13. Nikon Coolpix S630 Battery Cover Door Replacement: Schritt 12, Bild 1 von 1

    • Replace battery cover door.

    • Note: To reinstall a new battery cover door, make sure you have these parts: spring, rod, and the battery cover door.

    Übersetzen

  14. Nikon Coolpix S630 Battery Cover Door Replacement: Schritt 13, Bild 1 von 1

    • Place battery cover door back into place with spring between the insertion holes.

    • Using a tweezers, gently slide the rod through the insertion holes and through the spring.

    Übersetzen
Abschluss

To reassemble your device, follow these instructions in reverse order.

Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.

Autor:in

mit 3 anderen Mitwirkenden

Aulivia Bounchaleun

Mitglied seit: 04/19/13

10 Reputation

4 Anleitungen geschrieben

Auszeichnungen: 7

+ 4 weitere Auszeichnungen

Team

Cal Poly, Team 8-56, Johann Spring 2013 Mitglied von Cal Poly, Team 8-56, Johann Spring 2013

CPSU-JOHANN-S13S8G56

4 Mitglieder

18 Anleitungen geschrieben

Ein Kommentar

I am stuck on step 8. How am I supposed to hold it down and pull the front cover off. I can only get the corner up where the battery goes.

toolshell - Antwort

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 0

Letzte 7 Tage: 1

Letzte 30 Tage: 6

Insgesamt: 1,537