Einleitung

Use this guide to replace the memory compression board.

Ersatzteile

Kein Ersatzteil erforderlich.

Use your finger tip to pull the battery release tab toward the center of the D70.
  • Use your finger tip to pull the battery release tab toward the center of the D70.

  • Open the battery door and rotate it away from the bottom cover.

Kommentar hinzufügen

Pull the battery out of the D70.
  • Pull the battery out of the D70.

  • It may be necessary to wiggle the battery while pulling to free it from its pocket in the case.

Kommentar hinzufügen

Remove the following eight screws securing the bottom cover to the D70:
  • Remove the following eight screws securing the bottom cover to the D70:

    • Six 5.8 mm Phillips screws

    • One 10.7 mm Phillips screws

    • One 8.2 mm Phillips screws

Kommentar hinzufügen

Carefully pull the bottom cover to separate it from the body of the D70. Remove the bottom cover from the D70.
  • Carefully pull the bottom cover to separate it from the body of the D70.

  • Remove the bottom cover from the D70.

Kommentar hinzufügen

Remove the four ZIF ribbon cables highlighted in red by using the following procedure: Use your fingernail to flip up the ZIF cable retaining flap on each socket. Be sure you are prying up the retaining flap, not the socket.
  • Remove the four ZIF ribbon cables highlighted in red by using the following procedure:

    • Use your fingernail to flip up the ZIF cable retaining flap on each socket.

    • Be sure you are prying up the retaining flap, not the socket.

    • Pull the ribbon cable straight out of its socket.

Kommentar hinzufügen

Carefully peel back the piece of tape covering the Compact Flash ribbon cable socket.
  • Carefully peel back the piece of tape covering the Compact Flash ribbon cable socket.

  • It is not necessary to completely remove this piece of tape.

Kommentar hinzufügen

Use your fingernails to carefully pull the ZIF cable lock away from its socket. Do not try to completely remove the ZIF cable lock. It will move about 1 mm and stop. Use a pair of tweezers to pull the Compact Flash ribbon cable out of its socket.
  • Use your fingernails to carefully pull the ZIF cable lock away from its socket.

  • Do not try to completely remove the ZIF cable lock. It will move about 1 mm and stop.

  • Use a pair of tweezers to pull the Compact Flash ribbon cable out of its socket.

Kommentar hinzufügen

Be sure not to lose the small iron core around the DC-In ribbon cable.
  • Be sure not to lose the small iron core around the DC-In ribbon cable.

Kommentar hinzufügen

Remove the four 4.3 mm Phillips screws securing the memory compression board to the D70.
  • Remove the four 4.3 mm Phillips screws securing the memory compression board to the D70.

Kommentar hinzufügen

Use a pair of tweezers to pull the USB connector bracket away from the edge of the memory compression board.
  • Use a pair of tweezers to pull the USB connector bracket away from the edge of the memory compression board.

Kommentar hinzufügen

Grab the memory compression board by its edges at the position shown in the first picture. Pull the memory compression board straight up off the DC/DC board to avoid damaging the connector on the underside of the memory compression board.
  • Grab the memory compression board by its edges at the position shown in the first picture.

  • Pull the memory compression board straight up off the DC/DC board to avoid damaging the connector on the underside of the memory compression board.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

3 weitere Nutzer haben diese Anleitung absolviert.

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 2

Letzte 7 Tage: 4

Letzte 30 Tage: 8

Insgesamt: 22,882