Einleitung
SD board prerequisite guide.
Was du brauchst
-
-
Remove the two 4.5 mm Phillips screws securing the SD board to the motherboard.
-
-
-
-
Use the flat end of a spudger to pry the SD board ribbon cable connector off its socket on the motherboard.
-
-
-
Insert the flat end of a spudger between the SD board and the motherboard.
-
Run the spudger along the sides of the SD board to free it from the adhesive pad holding it in place.
-
Once completely freed, lift the SD board straight off the motherboard.
-
Fast fertig!
To reassemble your device, follow these instructions in reverse order.
Abschluss
To reassemble your device, follow these instructions in reverse order.
