Einleitung

If you can't hear the other line, then your speaker is broken. Use this guide in order to replace the damaged speakerphone speaker.

Ersatzteile

Kein Ersatzteil erforderlich.

Flip the phone over to view the back.
  • Flip the phone over to view the back.

  • Remove the power and phone cords.

Kommentar hinzufügen

Remove the seven 8mm Phillips #2 screws.
  • Remove the seven 8mm Phillips #2 screws.

Kommentar hinzufügen

  • Lift up the back cover slowly because there are still wires attached to the circuit board.

  • Lifting the back cover should not require a lot of force; simply lift with your fingertips.

Kommentar hinzufügen

  • Disconnect the rubber piece by pulling it out of the slot, freeing the back cover completely.

Kommentar hinzufügen

  • Remove the six 8mm Phillips #2 screws.

  • Pull the speaker phone cover straight up.

Kommentar hinzufügen

  • Lift the speaker straight up.

  • The speaker may need to be slightly wiggled in order to loosen and remove.

Kommentar hinzufügen

  • Cut the red and white wires as close to the speaker as possible.

  • Wire cutters are preferred, but normal scissors are fine too.

Kommentar hinzufügen

  • Solder wires to new speaker.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Ein weiterer Nutzer hat diese Anleitung absolviert.

Elizabeth

Mitglied seit 21.01.2012

160 Reputation

3 Anleitungen geschrieben

Team

Cal Poly, Team 10-35, Amido Winter 2012 Mitglied von Cal Poly, Team 10-35, Amido Winter 2012

CPSU-AMIDO-W12S10G35

4 Mitglieder

5 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 2

Insgesamt: 947