Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Einleitung
This guide will outline how to replace the fan inside the heating component.
Was du brauchst
-
-
Lay the popper on its side.
-
Remove the five 12mm Philips #2 screws around the perimeter of the base with the Phillips #2 screwdriver.
-
Remove the two 15mm Philips #2 screws in the center of the base with the Phillips #2 screwdriver.
-
-
-
Flip the base over to view the interior of the base panel.
-
Unscrew the two 10 mm Philips #2 screws from the base panel.
-
Remove the base and set it aside.
-
-
-
Locate the power switch connected to the side of the housing.
-
Pinch the sides of the power switch.
-
Push the power button up and out of the housing.
-
-
-
Remove the wires connected to the power switch that should be detached from the housing.
-
Gently pry the wires loose from the power switch with the plastic opening tool.
-
-
-
-
Remove the power switch from the housing unit.
-
You can now replace the power switch, if necessary.
-
-
-
Gently remove the heating component from the popper.
-
Unscrew the four screws (11mm Philips #2 screws) that connect the white top to the housing.
-
-
-
Now that the white top is disconnected from the housing, remove the heating component from inside the device.
-
-
-
Unscrew the three screws (10 mm Philips #2 screws) that hold the heating component together.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.
Team
Cal Poly, Team 16-57, Forte Fall 2012 Mitglied von Cal Poly, Team 16-57, Forte Fall 2012
CPSU-FORTE-F12S16G57
5 Mitglieder
6 Anleitungen geschrieben
