Einleitung

Removal of the front plate to get into the logic board, lens, etc.

Ersatzteile

Kein Ersatzteil erforderlich.

  1. Flip camera so you are looking at the bottom.
    • Flip camera so you are looking at the bottom.

    • Unscrew all 5 base plate screws.

    Kommentar hinzufügen

  2. Lift open retainer clip by sliding the clip to the left and letting the clip pop up.
    • Lift open retainer clip by sliding the clip to the left and letting the clip pop up.

    Kommentar hinzufügen

    • Unscrew the single screw located next to the battery slot.

    Kommentar hinzufügen

    • Turn the camera so that the USB, AV and DC in/out rubber plate it facing you.

    • Lift the rubber plate exposing the ports beneath.

    Kommentar hinzufügen

    • Unscrew the 2 screws next to the USB and AC ports.

    Kommentar hinzufügen

    • Use a flathead screwdriver or another flat opening tool to pry the faceplate from the whole device.

    Kommentar hinzufügen

    • Pull off the faceplate to reveal the inside of the camera.

    • Be careful of the connector that goes from the faceplate to the motherboard . Disconnecting this line will cause the camera not not power on through the on/off switch anymore.

    Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Katie

Mitglied seit 15.04.2010

25 Reputation

3 Anleitungen geschrieben

Team

Cal Poly, Team 28-23, Regan Spring 2010 Mitglied von Cal Poly, Team 28-23, Regan Spring 2010

CPSU-REGAN-S10S28G23

4 Mitglieder

7 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 0

Insgesamt: 1,499