Einleitung
This guide will show you how to remove and replace the lens box unit on the Olympus VR-350.
Was du brauchst
-
-
Remove the two 4mm screws from each side of the camera with a Phillips PH000 screwdriver.
-
-
-
Remove the four 4mm screws from the bottom of the camera with a Phillips PH000 screwdriver.
-
-
-
Use the plastic opening tools and your fingers to pry the front plate from the camera.
-
-
-
-
Using the Phillips PH000 screwdriver, remove the 4mm screw from the bottom left corner of the button plate located under the button membrane.
-
-
-
Remove the metal plate that was underneath the LCD screen by removing the four 4 mm screws with the Phillips PH000 screwdriver.
-
-
-
Remove the orange ribbon cable from the connector on the left side of the motherboard.
-
To do this, gently lift up the small grey clasp and pull the cable ribbon.
-
-
-
There are two other small ribbon cables under the motherboard connected to the lens box. Pull them out from the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
5 weitere Nutzer:innen haben diese Anleitung absolviert.
Team
USF Tampa, Team 1-3, Leahy Winter 2015 Mitglied von USF Tampa, Team 1-3, Leahy Winter 2015
USFT-LEAHY-W15S1G3
3 Mitglieder
10 Anleitungen geschrieben
Ein Kommentar
Worked for a SH-21, with a couple of extra screws to remove. Thank you!
