Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.
Was du brauchst
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Power off the phone by holding down the rectangular power button on right side and pressing the red button that says "Power off."
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the two 1mm Torx #2 screws at the bottom of the phone by rotating the screwdriver counter-clockwise.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Locate the sim card on the right side of the phone.
-
Insert the SIM ejector screwdriver bit into the hole left of the sim card holder by applying pressure.
-
Remove the sim card holder by pulling it out with your fingers.
-
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Insert the plastic iFixit opening tool between the the plastic rim of the screen and the metal edge of the phone.
-
Place a suction cup on the screen to gain more leverage when separating the screen from the back plate.
-
Moving right to left around the phone, carefully pry the screen away from the back plate by wiggling the iFixit opening tool and pulling the suction cup in the opposite direction.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Locate the metal connector cap on the upper half of the device directly above the battery.
-
Remove the 1mm Phillips #0 screw from the metal connector cap by rotating the screwdriver counter-clockwise.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Carefully pop out the metal connector cap with the nylon spudger and remove it by pulling up.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Locate the two connectors directly above the battery on the left side of the device.
-
Remove the battery connector cable located to the right of the charging port connector cable using a nylon spudger by prying underneath it and popping it up.
-
Remove the charging port connector cable to the left of the battery cable using a nylon spudger by prying underneath it and popping it up.
-