Einleitung
If the device does not charge and the battery is functional, you may have a broken charging port. This guide will demonstrate the steps needed to replace a broken charging port.
Was du brauchst
-
-
Remove gimbal from base handle by loosening round plate found at the top of the handle.
-
-
-
Use Phillips #00 screwdriver to remove the three screws found on the gimbal stabilizer to detach handle from gimbal.
-
Carefully detach handle from gimbal and disconnect the cable that connects the two.
-
-
-
Locate the hex screws found at the top base of the handle, and unscrew using the 1.5mm hex screwdriver.
-
-
-
-
Remove the quick release PCBA by locating the connecting wires and release the ribbon cable with tweezers.
-
Use the spudger to pry open and remove the face plate, starting at the back of the handle.
-
-
-
Locate four screws directly on top of handle.
-
Unscrew the silver, bottom two screws, that are closest to the face plate using the 00 screwdriver.
-
Unscrew the black, top two screws, located furthest from the face plate, using the 0 screwdriver.
-
Remove the remaining two screws found on the front of the faceplate.
-
Remove the rest of the face plate shell.
I know. - Nowhere. You need buy another gimbal (non-working) for a parts. By the way, it will be good to make a manual for other disassembling of a gimbal - I mean rotating parts. Some info of this can be found in this video on Youtube: https://www.youtube.com/watch?v=-5Xi-b8s...
But not too much :(
-
-
-
Remove the top left screw on the joystick panel with Phillips #00 screwdriver.
-
Lift faceplate holding joystick module.
-
-
-
Remove the bottom right screw on the joystick panel with the #00 Phillips screwdriver.
-
-
-
Hold down the larger of the two ribbon cables, and pull on circuit board with a constant and careful down and out motion.
-
-
-
Remove the two screws from the green charging module and the two screws on the grey plate and remove from handle.
-
Replace charging module.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Team
USF Tampa, Team S2-G1, Nance Fall 2017 Mitglied von USF Tampa, Team S2-G1, Nance Fall 2017
USFT-NANCE-F17S2G1
4 Mitglieder
12 Anleitungen geschrieben
3 Kommentare
Where can I buy a replacement port? Can’t find one with google.
Where can I buy the part. ?
This step isn't clear. How is the ring removed? Twist? Pry?
Jo Dee Lee - Antwort
Same question for me
Guitt97ii -
Tried for hours. Seems it’s glued on?
Jo Dee Lee - Antwort
ok, the top cap is screwed on. I used a double sided tape around it to have a better grip and just twisted it. The cap has thread lock in it.
Jo Dee Lee - Antwort
You passed this step?
Guitt97ii -
U passed this step???
Guitt97ii -
No solution for this step?
Guitt97ii - Antwort