Einleitung
Since replacing the cable requires the use of a soldering iron, there is a risk of burning yourself or damaging the controllers logic board.
Was du brauchst
-
-
Loosen the seven 11 mm Phillips #0 screws located on the back of the controller.
-
-
-
-
The cable connects to the logic board with a white connector. Above the right joystick, there are four solder pins labeled GND, VCC, DM, and DP.
-
-
-
Using your new cable, solder the white connector to the logic board. Be sure to have the cables facing towards the inside of the logic board.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
5 weitere Nutzer:innen haben diese Anleitung absolviert.
4 Kommentare
where can I find a replacement cable to perform this precedure with?
yes!! i would like to know too.. i have been searching for long time for that cable
Android cable
Wayne -