Zum Hauptinhalt wechseln

Repariere deine Sachen

Recht auf Reparatur

Werkzeug & Ersatzteile

Einleitung

I decided to create this guide because i got *triggerred* trying to reassemble the PS4 Dualshock 4 Controller

Ersatzteile

Keine Ersatzteile angegeben.

  1. Remove these two triggers and springs from the backplate. Find which trigger goes on which side and put the springs in the trigger part facing towards the inside of the controller.
    • Remove these two triggers and springs from the backplate.

    • Find which trigger goes on which side and put the springs in the trigger part facing towards the inside of the controller.

  2. On these two clips... Push down the trigger until it clicks on both sides.
    • On these two clips...

    • Push down the trigger until it clicks on both sides.

    • Make sure that the one spring part is inside the rail (marked cyan) and the other outside the whole assembly (green).

    The top part of the spring will slide down into the rail(groove/cutout) rather than the bottom part of the spring sliding down into the rail and the bottom part of the spring will push up against the concaved interior of the trigger housing. Hope this helps.

    Steve Dave - Antwort

  3. Nintendo Switch Kits

    Eine schnelle Lösung, um wieder ins Spiel zu kommen

    Switch Kits kaufen

    Nintendo Switch Kits

    Eine schnelle Lösung, um wieder ins Spiel zu kommen

    Switch Kits kaufen
  4. Connect the light bar cable using your fingers. Make sure it is fully pushed down and that is plugged in the right way.
    • Connect the light bar cable using your fingers. Make sure it is fully pushed down and that is plugged in the right way.

  5. close the cover starting from the side of the triggers. Don't worry if it's a bit hard to do so, but be careful so you don't break the plastic between the trigger and the bumper. Push down until it clicks everywhere.
    • close the cover starting from the side of the triggers. Don't worry if it's a bit hard to do so, but be careful so you don't break the plastic between the trigger and the bumper.

    • Push down until it clicks everywhere.

    • Finally, screw in these four screws using a PH0 screwdriver.

    Excelente, excelentes fotos, me ayudo muchisimo

    Pedro Bortot - Antwort

Ziellinie

10 weitere Nutzer haben diese Anleitung absolviert.

Commandblock6417

Mitglied seit: 01.12.2018

1.586 Reputation

4 Anleitungen geschrieben

Thank you so much! I had a ps4 controller that had a broken r2 button and i had gotten a replacement (which is now having battery issues) Today I took the old controller apart… the spring had come out of the rail. That was it!

Dee - Antwort

This guide is wrong. The top part spring should be inside the trigger, if you look at the other trigger it’s not exposed.

https://pureplaystation.com/wp-content/u...

Angus Yung - Antwort

Thanks for pointing it out. I do not have this controller anymore as it was from a repair job so unfortunately, I cannot correct it. If you or someone else happens to have one and is able to take high-quality pictures I’d be more than grateful to accept your correction.

Commandblock6417 -

Kommentar hinzufügen

Statistik anzeigen:

Letzten 24 Stunden: 13

Letzten 7 Tage: 152

Letzten 30 Tage: 709

Insgesamt: 7,114