Einleitung
I decided to create this guide because i got *triggerred* trying to reassemble the PS4 Dualshock 4 Controller
Was du brauchst
-
-
Remove these two triggers and springs from the backplate.
-
Find which trigger goes on which side and put the springs in the trigger part facing towards the inside of the controller.
-
-
-
On these two clips...
-
Push down the trigger until it clicks on both sides.
-
-
-
-
Connect the light bar cable using your fingers. Make sure it is fully pushed down and that is plugged in the right way.
-
-
-
close the cover starting from the side of the triggers. Don't worry if it's a bit hard to do so, but be careful so you don't break the plastic between the trigger and the bumper.
-
Push down until it clicks everywhere.
-
Finally, screw in these four screws using a PH0 screwdriver.
-
Rückgängig: Ich habe diese Anleitung nicht absolviert.
23 weitere Nutzer:innen haben diese Anleitung absolviert.
3 Kommentare
This guide is wrong. The top part spring should be inside the trigger, if you look at the other trigger it’s not exposed.
Thanks for pointing it out. I do not have this controller anymore as it was from a repair job so unfortunately, I cannot correct it. If you or someone else happens to have one and is able to take high-quality pictures I’d be more than grateful to accept your correction.
Devnol -
