Einleitung

Use this guide to put a fresh analog joystick into the PSP Go!

Unscrew the four Phillips screws on the back of the PSP Go.
  • Unscrew the four Phillips screws on the back of the PSP Go.

  • Rotate the PSP so you can see the top of the device.

  • Unscrew the two Phillips screws next to the volume buttons.

Kommentar hinzufügen

Use a plastic opening tool around the perimeter of the back cover to loosen it on all sides.
  • Use a plastic opening tool around the perimeter of the back cover to loosen it on all sides.

  • Open the back cover by gently lifting the right side, and rotating it to the left side (as if you were opening a book).

  • Be careful not to rotate the back cover from the bottom, as you will break the plastic screw holes on top of the device.

Kommentar hinzufügen

  • Pull the top cover upwards gently from its housing.

Kommentar hinzufügen

  • Remove the two Phillips screws holding the bottom plate.

  • Gently lift the bottom plate away from the device.

Kommentar hinzufügen

  • Use a #00 Phillips screwdriver to remove both screws holding the analog joystick in place.

Kommentar hinzufügen

  • Use a plastic opening tool to gently flip up the analog joystick's cable connector.

  • Use your fingers or tweezers to gently pull out the analog joystick cable from its connector.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

4 weitere Nutzer haben diese Anleitung absolviert.

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 12

Letzte 30 Tage: 41

Insgesamt: 18,473