Zum Hauptinhalt wechseln

Einleitung

If your Palm Treo phone call audio is muffled or not working at all, use this guide to replace the earphone.

Be aware that this guide only provides a solution to the Palm Treo cell phone, and the replacement of its earphone.

Note that the guide uses two different screwdrivers, and an iFixIt opening tool. Having these tools on hand are essential to completing the guide.

  1. Position the phone so the screen faces down.
    • Position the phone so the screen faces down.

    • Remove the stylus found on the back of the phone.

  2. To remove the battery cover, hold down the button in the middle of the phone's back.
    • To remove the battery cover, hold down the button in the middle of the phone's back.

    • Slide the cover down to remove it, and set the cover aside.

  3. Lift the edge of the battery, separating contact points, and pull out as pictured. Lift the edge of the battery, separating contact points, and pull out as pictured.
    • Lift the edge of the battery, separating contact points, and pull out as pictured.

  4. Remove the round rubber cover on the back of the phone located immediately below the antenna.
    • Remove the round rubber cover on the back of the phone located immediately below the antenna.

    • This will uncover a screw that will be removed in the next step.

  5. Remove the six 6.9 mm screws as pictured with a T5 Torx screwdriver. Remove the single 9.8 mm screw next to the antenna on the back plate using a Phillips #00 screwdriver.
    • Remove the six 6.9 mm screws as pictured with a T5 Torx screwdriver.

    • Remove the single 9.8 mm screw next to the antenna on the back plate using a Phillips #00 screwdriver.

  6. Remove the antenna.
    • Remove the antenna.

  7. Pry the back cover off using an iFixIt opening tool. The back cover is attached by several small clips on the inside.
    • Pry the back cover off using an iFixIt opening tool.

    • The back cover is attached by several small clips on the inside.

  8. Disconnect the ribbon cable before removing the motherboard. Unclip the gray tab. Pull out the orange ribbon cable.
    • Disconnect the ribbon cable before removing the motherboard.

    • Unclip the gray tab.

    • Pull out the orange ribbon cable.

  9. Pull off the motherboard. Pull off the motherboard.
    • Pull off the motherboard.

  10. Pull out the earphone by grabbing the black rubber piece identified in the picture. Pull out the earphone by grabbing the black rubber piece identified in the picture. Pull out the earphone by grabbing the black rubber piece identified in the picture.
    • Pull out the earphone by grabbing the black rubber piece identified in the picture.

Abschluss

To reassemble your device, follow these instructions in reverse order.

cgood

Mitglied seit: 28.10.2009

122 Reputation

7 Anleitungen geschrieben

Team

Cal Poly, Team 19-3, Maness Fall 2009 Mitglied von Cal Poly, Team 19-3, Maness Fall 2009

CPSU-MANESS-F09S19G3

4 Mitglieder

18 Anleitungen geschrieben

0 Kommentare

Kommentar hinzufügen

Seitenaufrufe:

Letzten 24 Stunden: 0

Letzten 7 Tage: 0

Letzten 30 Tage: 3

Insgesamt: 2,920