Zum Hauptinhalt wechseln

Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.

Palm Treo 680 Microphone Replacement

Was du brauchst

  1. Palm Treo 680 Microphone Replacement, Battery: Schritt 1, Bild 1 von 2 Palm Treo 680 Microphone Replacement, Battery: Schritt 1, Bild 2 von 2
    • Remove the battery cover by pressing on the small rectangular button located on the back of the phone.

  2. Palm Treo 680 Microphone Replacement: Schritt 2, Bild 1 von 1
    • Remove the battery by pulling it out towards you.

  3. Palm Treo 680 Microphone Replacement, Back Panel: Schritt 3, Bild 1 von 2 Palm Treo 680 Microphone Replacement, Back Panel: Schritt 3, Bild 2 von 2
    • Remove the stylus in order to access the screw.

    • Remove the 27mm top-left screw using a T6 Torx screwdriver.

  4. Palm Treo 680 Microphone Replacement: Schritt 4, Bild 1 von 2 Palm Treo 680 Microphone Replacement: Schritt 4, Bild 2 von 2
    • Using the spudger, remove the rubber rectangular cover located in the upper rear, right-hand corner.

    • Remove the 27mm screw using the T6 Torx screwdriver.

    • If there is a red Palm sticker covering this screw, puncture it to access the screw.

  5. Palm Treo 680 Microphone Replacement: Schritt 5, Bild 1 von 1
    • Remove the remaining two 27mm screws from the bottom using the T6 screwdriver.

  6. Palm Treo 680 Microphone Replacement: Schritt 6, Bild 1 von 3 Palm Treo 680 Microphone Replacement: Schritt 6, Bild 2 von 3 Palm Treo 680 Microphone Replacement: Schritt 6, Bild 3 von 3
    • Turn the phone so the screen is facing the right side.

    • Use a spudger to carefully separate the back panel from the front panel to access components inside the phone.

    • Separate the covers from the left side of the device as indicated in the picture.

    • The right side contains orange ribbons that are easily damaged.

  7. Palm Treo 680 Microphone Replacement, Microphone: Schritt 7, Bild 1 von 2 Palm Treo 680 Microphone Replacement, Microphone: Schritt 7, Bild 2 von 2
    • Using a pair of tweezers, grasp the blue rubber microphone.

    • Pull the rubber microphone up and back to remove it.

    • Now you have successfully removed the microphone.

Abschluss

To reassemble your device, follow these instructions in reverse order.

2 weitere Nutzer:innen haben diese Anleitung absolviert.

Maiya123

Mitglied seit: 10/22/09

51 Reputation

6 Anleitungen geschrieben

Team

Cal Poly, Team 6-4, Maness Fall 2009 Mitglied von Cal Poly, Team 6-4, Maness Fall 2009

CPSU-MANESS-F09S6G4

4 Mitglieder

12 Anleitungen geschrieben

0 Kommentare

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 0

Insgesamt: 4,132