Einleitung

This guide will show you how to remove the motherboard so you can replace it.

Ersatzteile

Kein Ersatzteil erforderlich.

  1. Move the switch on the battery door to the Open position.
    • Move the switch on the battery door to the Open position.

    • The door will automatically swing open after you let it go.

    Kommentar hinzufügen

  2. Push the small gray tab on the top right corner to the left. The battery will pop out slightly.
    • Push the small gray tab on the top right corner to the left. The battery will pop out slightly.

    • Keep your finger clear of the battery when it pops out.

    Kommentar hinzufügen

    • Push the memory card in and let go.

    • The memory card will pop out slightly.

    • Pull out the memory card.

    Kommentar hinzufügen

    • Unscrew the small screws on the sides of the camera.

    • The screws on the left side(#00P, 4.7mm) are longer than the screw on the right side(#00P, 3.3mm).

    Kommentar hinzufügen

    • Unscrew the three small screws on the bottom(#00P, 3.3mm).

    • The bottom will fall off.

    Kommentar hinzufügen

    • Lift up the bottom back cover by prying the bottom edge with the spudger.

    • Gently lift up the back cover with your hand from the bottom to the top.

    Kommentar hinzufügen

    • Lift the tabs on the ZIF connectors.

    • The ribbon cables should easily come out of the ZIF connectors.

    Kommentar hinzufügen

    • Using the spudger, pry off the top cover by gliding the spudger along the entire edge between the top cover and the front cover.

    • Be careful not to damage the cylindrical capacitor on the circuit board under the top cover.

    Kommentar hinzufügen

    • Remove the small screw in the hole towards the top of the camera(#00P, 5.4mm).

    Kommentar hinzufügen

    • Use the spudger to lift up the back logic board.

    • Using your fingers, gently wiggle and pull off the back motherboard.

    • You will hear a click when you lift it up.

    Kommentar hinzufügen

    • Remove the small screw holding down the lower motherboard(#00P, 3.2mm).

    Kommentar hinzufügen

    • Use the spudger to lift the upper tab from the main housing.

    • Gently lift the lower tab from the main body by prying it with your finger.

    • Gently pull off the plastic motherboard housing sideways.

    Kommentar hinzufügen

    • Gently lift the tabs on the ZIF connectors connecting the lens to the front motherboard.

    • Once you lift the tabs the ribbons should fall right out and the front motherboard should be free.

    Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Karissa

Mitglied seit 13.04.2012

50 Reputation

8 Anleitungen geschrieben

Team

Cal Poly, Team 6-23, Amido Spring 2012 Mitglied von Cal Poly, Team 6-23, Amido Spring 2012

CPSU-AMIDO-S12S6G23

4 Mitglieder

10 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 2

Letzte 30 Tage: 21

Insgesamt: 1,046