Ersatzteile

Kein Ersatzteil erforderlich.

Remove the battery and memory card from the device.
  • Remove the battery and memory card from the device.

Kommentar hinzufügen

Remove 4 screws from the right side of the camera.
  • Remove 4 screws from the right side of the camera.

    • There are two 3.4mm screws at the top.

    • There are two 2.2mm screws at the bottom.

Kommentar hinzufügen

Remove the single 3.4mm screw on the left side of the camera.
  • Remove the single 3.4mm screw on the left side of the camera.

Kommentar hinzufügen

Remove 5 screws from the base of the camera.
  • Remove 5 screws from the base of the camera.

    • There are two 2.2mm screws next to the battery compartment.

    • There are three 4mm screws around the tripod mount.

Kommentar hinzufügen

Slowly slide the back cover away from the device
  • Slowly slide the back cover away from the device

    • The back casing is held in place by two ribbon cables. Do not pull the back cover too far from the camera.

Kommentar hinzufügen

Detach both ribbon cables using a spudger. Use the tip of the spudger to lift the black clip upward, unlocking the ribbon cable.
  • Detach both ribbon cables using a spudger.

    • Use the tip of the spudger to lift the black clip upward, unlocking the ribbon cable.

Kommentar hinzufügen

Remove the back casing from the camera.
  • Remove the back casing from the camera.

Kommentar hinzufügen

Use the spudger to remove the ribbon cable connecting the lens casing to the circuit board by lifting up the black clip. Carefully remove the function switch cover. This unit snaps on and off.
  • Use the spudger to remove the ribbon cable connecting the lens casing to the circuit board by lifting up the black clip.

  • Carefully remove the function switch cover. This unit snaps on and off.

Kommentar hinzufügen

Carefully unsnap the front logic board from the rear logic board using a spudger.
  • Carefully unsnap the front logic board from the rear logic board using a spudger.

Kommentar hinzufügen

Slide the entire top part of the camera that is attached to the logic board, horizontally away from the camera. Slide the entire top part of the camera that is attached to the logic board, horizontally away from the camera.
  • Slide the entire top part of the camera that is attached to the logic board, horizontally away from the camera.

Kommentar hinzufügen

Remove the ribbon cable from the top connection panel by unlocking the black clip with a spudger. This leaves you with the logic board and the top connection panel separate and free from the camera This leaves you with the logic board and the top connection panel separate and free from the camera
  • Remove the ribbon cable from the top connection panel by unlocking the black clip with a spudger.

  • This leaves you with the logic board and the top connection panel separate and free from the camera

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Ben Canfield

Mitglied seit 10.10.2010

403 Reputation

3 Anleitungen geschrieben

Team

Cal Poly, Team 9-21, Regan Fall 2010 Mitglied von Cal Poly, Team 9-21, Regan Fall 2010

CPSU-REGAN-F10S9G21

4 Mitglieder

7 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 3

Letzte 30 Tage: 18

Insgesamt: 4,999