Parrot FLYPAD Joystick Replacement

Einleitung

This guide will walk you through steps to replace your joystick.

Was du brauchst

Schritt 1 Joystick

Parrot FLYPAD Joystick Replacement, Joystick: Schritt 1, Bild 1 von 1

In diesem Schritt verwendetes Werkzeug:

Magnetic Project Mat

$19.95

Kaufen

Total of 6 Screws are located in the back of the controller.
Four 0.9mm T6 screws
Two 0.1mm T6 screws
Flip the Flypad over.
Remove the six screws using a T6 screwdriver.
Use a Magnetic Mat to prevent loss of screws. Set aside.

Übersetzen

Schritt 2

Flip the Flypad over again and separate the front and back. Be sure to remove the foam adhesive that connects the front plate to the motherboard.
Be aware that the Buttons (L1,R1) may fall out. Remember to put them back in place during reassembly.
Use Ph0 tool to remove the screws holding the motherboard in place.
Gently remove the motherboard from the front plate.

Übersetzen

The FLYPAD’s that come with the FPV kit do not have the weights and the rumble motor. The sticks are also not removable.

Heath - 24. Feb 2018 Antwort

Schritt 3

Pop the joysticks out by pulling gently.

Übersetzen

Please add the removal of the motherboard screws. Also I have 3 of these controllers. The oldest has PHILLIPS head screws. The newest has the T6 screws. Just FYI.

Heath - 24. Feb 2018 Antwort