Einleitung

This guide will teach the reader how to install a new case of the camera. If the case on the camera gets cracked or is starting to come apart, this guide will help to replace it with a new case.

Ersatzteile

Kein Ersatzteil erforderlich.

Flip the camera over so the bottom is facing you. Flip the camera over so the bottom is facing you.
  • Flip the camera over so the bottom is facing you.

Kommentar hinzufügen

Open the cover on the bottom by sliding it in the direction of the arrow. Open the cover on the bottom by sliding it in the direction of the arrow.
  • Open the cover on the bottom by sliding it in the direction of the arrow.

Kommentar hinzufügen

Remove the batteries by pulling up on the top with your fingers.
  • Remove the batteries by pulling up on the top with your fingers.

Kommentar hinzufügen

Unless otherwise stated, use a phillips #00 screwdriver to remove screws.
  • Unless otherwise stated, use a phillips #00 screwdriver to remove screws.

  • Remove the two 4.70mm screws in the bottom of the plastic casing.

Kommentar hinzufügen

Remove the four 4.70mm screws in the left side of the camera. Remove the four 4.70mm screws in the left side of the camera.
  • Remove the four 4.70mm screws in the left side of the camera.

Kommentar hinzufügen

Now on the side with the strap, remove the other four 4.70mm screws. Now on the side with the strap, remove the other four 4.70mm screws.
  • Now on the side with the strap, remove the other four 4.70mm screws.

Kommentar hinzufügen

Use your thumbs to pry the case apart. It is easiest to pry to case apart if your start at the bottom. The case should come apart with minimal effort. If  it doesn't, you can use a tool such as a Spudger or Plastic Opening tool.
  • Use your thumbs to pry the case apart.

  • It is easiest to pry to case apart if your start at the bottom.

  • The case should come apart with minimal effort. If it doesn't, you can use a tool such as a Spudger or Plastic Opening tool.

Kommentar hinzufügen

This step requires a significant amount of force.
  • This step requires a significant amount of force.

  • Pull the bottom half of the inner camera out of case about half an inch. This may be difficult and force is necessary.

Kommentar hinzufügen

While pulling the camera out of the case, note the small soft plastic cover on the side of the camera. This cover will detach from the rest of the device. Once the bottom of the inner camera is pulled out about an inch and a half, pull the device out completely.
  • While pulling the camera out of the case, note the small soft plastic cover on the side of the camera. This cover will detach from the rest of the device.

  • Once the bottom of the inner camera is pulled out about an inch and a half, pull the device out completely.

  • When completely removing the device from the case, use a firm grasp with your hands for stability and control.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Clay Young

Mitglied seit 04.04.2012

191 Reputation

2 Anleitungen geschrieben

Team

Cal Poly, Team 15-13, Forte Spring 2012 Mitglied von Cal Poly, Team 15-13, Forte Spring 2012

CPSU-FORTE-S12S15G13

5 Mitglieder

5 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 2

Letzte 30 Tage: 10

Insgesamt: 1,291