Was du brauchst
-
-
Pull the AC-In cables upward to remove the AC inlet from the lower case.
-
-
-
Use the flat end of a spudger to pry both antenna connectors up from their sockets on the motherboard.
-
-
-
Pull the control board ribbon cable up and out of its socket on the motherboard.
-
Remove the control board.
-
-
-
-
Turn the PS3 over and lay it on its backside.
-
Use the flat edge of a metal spudger to pop up the small access door on the bottom cover near the front of the PS3.
-
Remove the blue Phillips screw hidden under the access door.
-
-
-
Slide the hard drive bay cover toward the right side of the lower case, then pull it away from the front edge to remove it from the PS3.
-
-
-
Remove the following five screws securing the motherboard assembly to the lower case:
-
Two silver 6 mm Phillips
-
Three black 8 mm Phillips
-
-
-
Lift the motherboard assembly from its front edge and remove it from the lower case, minding the antenna cable still attached to the lower case.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
