Zum Hauptinhalt wechseln

Polaroid PTAB7XC Battery Replacement

Was du brauchst

  1. Polaroid PTAB7XC Battery Replacement, Battery: Schritt 1, Bild 1 von 2 Polaroid PTAB7XC Battery Replacement, Battery: Schritt 1, Bild 2 von 2
    • Remove the two 7 mm screws on the top of the device using a J00 Phillips screwdriver, turning them counterclockwise.

    • If the screw heads have corroded or been stripped, it may be necessary to use a larger screwdriver head, such as the J0.

  2. Polaroid PTAB7XC Battery Replacement: Schritt 2, Bild 1 von 3 Polaroid PTAB7XC Battery Replacement: Schritt 2, Bild 2 von 3 Polaroid PTAB7XC Battery Replacement: Schritt 2, Bild 3 von 3
    • Pry the seam between the screen and the case on all four sides with a large plastic opening tool until the plastic case comes off.

    • Lift the device off of the case and flip over the device so that it sits screen side down.

    • The device is now free from the plastic casing.

    • The power and/or volume buttons may fall out at this point. There is no problem with this; however, be sure to remember to reinstall them when reassembling the device.

  3. Polaroid PTAB7XC Battery Replacement: Schritt 3, Bild 1 von 2 Polaroid PTAB7XC Battery Replacement: Schritt 3, Bild 2 von 2
    In diesem Schritt verwendetes Werkzeug:
    Plastic Cards
    $2.99
    Kaufen
    • Wedge a plastic card beneath the battery unit.

    • Wiggle the card side to side and up and down gently until the glue sealing the battery to the device is broken.

    • Do not rupture the battery; it poses a serious safety hazard.

    • There is a plastic bag around the battery; if torn or stretched, there is no safety hazard.

  4. Polaroid PTAB7XC Battery Replacement: Schritt 4, Bild 1 von 3 Polaroid PTAB7XC Battery Replacement: Schritt 4, Bild 2 von 3 Polaroid PTAB7XC Battery Replacement: Schritt 4, Bild 3 von 3
    • Set the device on a heat safe surface.

    • Desolder from the motherboard the red wire that connects to the battery unit.

    • Desolder from the motherboard the black wire that connects to the battery unit.

    • Lift the battery out of the device using your hands.

    • The battery is now free from the device.

    • If either of the wires do not come completely free when desoldering, use tweezers to gently pull them free.

Abschluss

To reassemble your device, follow these instructions in reverse order.

4 weitere Nutzer:innen haben diese Anleitung absolviert.

Ein Kommentar

This tablet has the exact same setup as the 2011-2012 nextbook part might be interchangeable with this tablet .

Walker wallace - Antwort

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 1

Insgesamt: 2,069