Einleitung

This is straight forward and should be easily accomplished. The toughest part on this repair is to remove the front case. It does bind a bit around the USB port, but will free with a bit of shimming.

Ersatzteile

Kein Ersatzteil erforderlich.

  1. remove the batteries, the memory card as well as the carrying strip (if so equipped). Remove the 2 screws on the right hand side. Remove the 2 screws on the left hand side.
    • remove the batteries, the memory card as well as the carrying strip (if so equipped).

    • Remove the 2 screws on the right hand side.

    • Remove the 2 screws on the left hand side.

  2. Kostenloser Versand für alle Bestellungen über 100,00 $ oder mit einem Pro Tech Toolkit!

    Schau dich im Store um

    Schon mal was repariert? Genial!

    Teile ein Foto deiner Reparatur mit dem Hashtag #ImAGenius

    Wir sind alle Genies

    Teile ein Foto deiner Reparatur mit dem Hashtag #ImAGenius

  3. One more screw on the bottom, underneath the manufacturer's label. Start spitting the case from the battery compartment. You can use a plastic opening tool, or your finger nails. It does bind a bit at the USB port side, but will separate pretty quick. With the back removed, the large LCD becomes immediately visible. There are no fasteners, it just rests inside the tray.
    • One more screw on the bottom, underneath the manufacturer's label.

    • Start spitting the case from the battery compartment. You can use a plastic opening tool, or your finger nails. It does bind a bit at the USB port side, but will separate pretty quick.

    • With the back removed, the large LCD becomes immediately visible. There are no fasteners, it just rests inside the tray.

  4. Lift the LCD out of the tray and move it to the right of the tray. The cable is still attached to the logic board via a latch. With the plastic opening tool, or your fingernails, gently flip the latch to the left side. This will free the LCD cable. Remove the LCD and install your new one.
    • Lift the LCD out of the tray and move it to the right of the tray. The cable is still attached to the logic board via a latch.

    • With the plastic opening tool, or your fingernails, gently flip the latch to the left side. This will free the LCD cable. Remove the LCD and install your new one.

Abschluss

To reassemble your device, follow these instructions in reverse order.

oldturkey03

Mitglied seit: 29.09.2010

559.772 Reputation

101 Anleitungen geschrieben

Team

OTS Mitglied von OTS

Business

1 Mitglied

123 Anleitungen geschrieben

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 1

Letzte 30 Tage: 4

Insgesamt: 928