Einleitung

Removing the hard drive of the Power Mac G4 Quicksilver for replacement.

Ersatzteile

Kein Ersatzteil erforderlich.

  1. The handle to open your computer is located on top of the right side panel.
    • The handle to open your computer is located on top of the right side panel.

    Kommentar hinzufügen

  2. Grab the circular handle and pull outward.
    • Grab the circular handle and pull outward.

    Kommentar hinzufügen

    • Your computer is now open and ready for repair.

    Kommentar hinzufügen

    • The hard drive is located in the rear right corner of the case.

    Kommentar hinzufügen

    • Unplug the IDE ribbon cable. This is the wide flat grey cable.

    Kommentar hinzufügen

    • Remove the screw holding down the hard drive enclosure.

    Kommentar hinzufügen

    • Lift the hard drive enclosure straight up and out.

    • Be carful not to pull the attached cable.

    Kommentar hinzufügen

    • Disconnect the MOLEX connector.

    • This cable may be hard to remove. Grab the connector on either side as pictured and wiggle it back and forth to remove it.

    Kommentar hinzufügen

    • Remove the four screws holding the hard drive to the enclosure.

    Kommentar hinzufügen

    • Your hard drive is now free from the enclosure and is ready to be replaced.

    Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

8 weitere Nutzer haben diese Anleitung absolviert.

Ryan Bylard

Mitglied seit 20.01.2010

1.251 Reputation

5 Anleitungen geschrieben

Team

Cal Poly, Team 14-41, Regan Winter 2010 Mitglied von Cal Poly, Team 14-41, Regan Winter 2010

CPSU-REGAN-W10S14G41

4 Mitglieder

10 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 1

Letzte 7 Tage: 8

Letzte 30 Tage: 40

Insgesamt: 13,315